Scourge of War Boards

IronBMike wrote:

Kerflumoxed wrote:

Speaking of the toolbar, has anyone considered allowing the brigade commander's (which is the level I most enjoy) have a marching option that would allow the Battalions (Regiments) to move in a "Column of Brigades" (I forget the correct command) with one behind the other in open terrain as is done when "road marching" rather then spreading out?

Thanks for the consideration.

Jack Hanger
Fremont, NE

I like this idea.

Isn't this in as road column already?

norb wrote:

IronBMike wrote:

Kerflumoxed wrote:

Speaking of the toolbar, has anyone considered allowing the brigade commander's (which is the level I most enjoy) have a marching option that would allow the Battalions (Regiments) to move in a "Column of Brigades" (I forget the correct command) with one behind the other in open terrain as is done when "road marching" rather then spreading out?

Thanks for the consideration.

Jack Hanger
Fremont, NE

I like this idea.

Isn't this in as road column already?

Jack, is this what you are looking for? Or are you talking about a formation used when the troops are marching on a road?

"Column of regiments by brigade" which would look like this

XXXXXXXXXX



XXXXXXXXXX



XXXXXXXXXX



XXXXXXXXXX

Where each X represents a company in a 4 regiment brigade. Note that this formation gives the 3 following regiments wheeling room in relation to the regiment in front of them.

"Column of regiments by brigade in mass" would look like this

XXXXXXXXXX

XXXXXXXXXX

XXXXXXXXXX

XXXXXXXXXX

As seen above, there is no room for the following 3 regiments to maneuver in relation to the leading regiment, but the brigade takes up less room front to back. Obviously, both these formations are too wide for road travel and as Jack said would be used on open ground.

Will have to look for the command...memory is going fast! They say the second thing that goes IS the memory. Can't remember the first thing to go.

Anyway, what I am talking about is when the Battalion (Regiment) is put into a column of fours (Battalion. Right (or Left) - FACE. Forward, MARCH!) with one regiment following behind:

XXXX
XXXX 1st Regiment
XXXX
XXXX
XXXX
XXXX
XXXX
XXXX

XXXX
XXXX 2nd Regiment
XXXX
XXXX
and so forth.

Rather than what is currently in the game (excempt for road marches):

1 Rgt 2 Rgt 3 Rgt 4Rgt
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX

In actual practice, this would be important, especially through wooded terrain for the artillery, as it allows the woods to be "broken" down and successive guns would "follow the trail" (which would be another concept altogether). In a recent game, I wanted to move a brigade between a fenced field and nearby woods. In order for me to move between these two obstacles, I had to individually move each Battalion (Regiment). If I selected parallel routes of march as in TC2M, one Battalion moved in the open while the remaining four Regiments (was using the Stonewall Brigade) "plowed" through the slower terrain.

Yes, this a wheel, but is not a "Wheel" command; rather it is "By Files Right (Left)" although I doubt it was issued as such because of the "Route Step."

Hope this makes sense!

Thanks

Jack Hanger
Fremont, NE

norb wrote:

IronBMike wrote:

Kerflumoxed wrote:

Speaking of the toolbar, has anyone considered allowing the brigade commander's (which is the level I most enjoy) have a marching option that would allow the Battalions (Regiments) to move in a "Column of Brigades" (I forget the correct command) with one behind the other in open terrain as is done when "road marching" rather then spreading out?

Thanks for the consideration.

Jack Hanger
Fremont, NE

I like this idea.

Isn't this in as road column already?

Essentially, yes! But unless I am missing something in TC2M (which is entirely possible, Norb), I can only use "road colum" on the roads. :blink: I would like to be able to use the same formation in open terrain which they did! :cheer:

Thanks

Jack Hanger
Fremont, NE

Little Powell wrote:

Cliffy - You wanted to know of more features; another one is the Go To Unit button. Which ever unit you have selected, you can hit a button the the tool bar and it takes you directly to that unit. No more searching around the map for the commander you have selected. This works well hand & hand with the last feature I mentioned. You can cycle through your commanders without the camera jumping around, then hit "Go To Unit" to focus on that commander. Very convenient.




Little Powell, the Got To Unit button sounds like a very useful feature. Was that your idea too?

Everyone bear with me. I'm still learning how to post on this board.

Dave

cliffy wrote:

Little Powell wrote:

Cliffy - You wanted to know of more features; another one is the Go To Unit button. Which ever unit you have selected, you can hit a button the the tool bar and it takes you directly to that unit. No more searching around the map for the commander you have selected. This works well hand & hand with the last feature I mentioned. You can cycle through your commanders without the camera jumping around, then hit "Go To Unit" to focus on that commander. Very convenient.




Little Powell, the Got To Unit button sounds like a very useful feature. Was that your idea too?

Everyone bear with me. I'm still learning how to post on this board.

Dave

Nah, not my idea. One of the other very talented team members came up with that one, not sure who.

Though I have not seen the new game, based on TC2M I'd second IronBMike's suggestion about toggling the map with the M key rather than having to click on the X to close it. This would make an already awesome game even easier to use.

Richmond

Actually, you hit the ESC key, that will close any open dialog.

Good to know; it does make things easier! Someday I'll learn to pay attention when I read the instructions . . .

Richmond

If ya don't ask.....

It's just good to know there actually is a developer that'll answer.